![]() ![]() I just left the hard drive and cdrom.ĭisc_a = D:\Emulators\pcem\drivers\ndishotfix98.IMAĬdrom_path = G:\Downloads\Downloads\Packard Bell Master CD. I also tried with removing any expansion cards ie soundblaster and rtl8029as. I get the error in the pcem log "Device failed to request command" that is the only line in the log as well. It seems to happen when certain cdrom images are mounted at boot. I start the machine it post but when it goes to boot it crashes. It happened a few times with the original merge and after the pci bus fixes. I keep getting a crash on pcem with the pb570 board. Sarah was the Hillary anything like that? I do remember borrowing on of my friends packard bell riser cards that had more pci slots and it worked on my pb600 motherboard. Mine had 2 isa and one pci on the riser card. If its similar to that it required a riser card for the expansion slots. I never had a packard bell based on a Hillary motherboard but I did have on based on the pb600. 4.0) (February 1995) Addeddate 09:52:30 Identifier packardbellmulti-mediamastercd170210rev.4. I should really add a warning about this though.įor the record, all the PCI boards have limitations here - the SiS496/497 and Premiere/PCI are limited to three devices total, PB520R supports 3 devices + onboard graphics, while the Advanced/EV, Advanced/ZP and 430VX clone support four. Packard Bell Multi-Media Master CD (170210 Rev. This is simply a limitation of the PB570 and there isn't much I can reliably do about it. From what I can see, the real machines with this board only ever had two PCI slots so this was never an issue.įor PCem, what this means is that if you had more than two PCI devices - say, an AudioPCI, a PCI network card and a Voodoo card - only two of them will actually appear to be present. This should leave three slots, however the BIOS seems to screw up IRQ mapping for the third slot so in practice it doesn't work. The PB570 BIOS only seems to support 2 PCI cards - the PIIX chip supports 4 devices, one of which is taken by the onboard graphics. Should also add this, before anyone stumbles into it by accident! I just left the hard drive and cdrom.ĭisc_a = D:\Emulators\pcem\drivers\ndishotfix98.IMAĬdrom_path = G:\Downloads\Downloads\Packard Bell Master CD.SarahWalker wrote: ↑ Sat 24 Feb, 2018 9:44 am ![]() I never had a packard bell based on a Hillary motherboard but I did have on based on the pb600. This Packard Bell Master CD - English Ref No: 6707430501 works perfectly on my Packard Bell 9019 XE PC with FL96 MCD/W95 BOOTFLOP UK Ref No: 6707570701 but must have original existing Packard Bell software installed on original HDD partition otherwise, it wont work. I should really add a warning about this though.įor the record, all the PCI boards have limitations here - the SiS496/497 and Premiere/PCI are limited to three devices total, PB520R supports 3 devices + onboard graphics, while the Advanced/EV, Advanced/ZP and 430VX clone support four. SarahWalker wrote: ↑ Sat 24 Feb, 2018 9:44 am
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |